GfG Instruments CC 28 Fixed Smart Transmitter for Combustible Gases

For the detection of Hydrogen, Acetone, Diethyl ether, Ethylene, Ethyl acetate, Hexane, Methane, N-Nonane, Propane, Isopropanol, Toluene, Acetylene, Benzene, n-Butane, Butane-iso, 2-Butanol, 2 Butanon (Methyl ethyl ketone), Cyclohexane, Dimethyl ether, Ethane, Ethanol, Heptane, Methanol, Methyl acetate, Methylisobutylketone, Octane, Pentane, Propane, Propylene, Xylene and Ammonia.

Full-featured smart transmitter for combustible gas measurement

Non-intrusive Autocal calibration

Expected sensor life of 5 years or longer

Also available for a wide range of toxic gas measurement

Increased safety design to reduce installation cost in potentially hazardous locations

ATEX EEx dem [1b] IIC T4

Proprietary, high performance combustible gas sensor

Available in three configurations-

Blind (no display)

Display

Display with local alarms

Superior Technology

In areas where combustible gas or vapor hazards may exist, GfG’s new CC 28 combustible transmitter is the perfect choice for reliable area monitoring. With its proven design, this ATEX certified transmitter offers an integrated explosion-proof buzzer and bright-alarm LEDs for reliable warning of combustible gas hazards (even in hazardous locations). This superior design provides warnings for immediate personnel, and ensures entire plant safety.

Easy handling

Smart sensor technology allows easy installation. Sensor replacement takes only a few seconds-simply plug in the sensor. User adjustments are performed at the transmitter with simple touch keys, or with the optional remote control interface (one person calibration).

RC2 remote control

Several combustible gases are lighter than air. With the transmitter mounted close to the ceiling, calibration can be difficult. The remote control for the CC 28 allows you to perform calibration or zero adjustments without the need of a ladder or lift. A flexible cable connects the remote control to the transmitter and displays the same reading as the display on the transmitter. With the remote control inspection,service and calibration can be performed easily by one person.

The sensor and the integrated temperature compensation provide highest measurement accuracy.

Low maintenance requirements and long sensor life reduce your cost of ownership.

Models

Model CC 28D allows you to read the gas concentration both at the transmitter and at the GMA controller. With the RC2 remote control - the CC 28 is easy to use and to operate even if it is mounted at the ceiling.
Model CC 28DA provides additional warning with bright integrated alarm LEDs and a buzzer.