Honeywell Analytics HA40- 4 Channel Controller
The HA40 controller has been discontinued since 12/31/2017
The Honeywell HA40 4 channel digital gas controller is designed to work in the harshest industrial or commercial environments. A NEMA4x and explosion proof enclosure allows you to place the controllers in all hazardous locations to monitor for toxic gases, combustible gases, and oxygen deficiency.
The controllers are easy to install and feature large graphical LCD display, standard 4-20mA inputs, and non-intrusive inputs for hazardous areas.
HA40 controller is also user friendly and easy to configure. A Graphic LCD Display shows monitored data as bar graphs, 30 minute trends and engineering units. A touch-and-magnetic keypad allows for non intrusive operation in potentially hazardous locations. Cal Mode offers push button zero /span calibration for direct sensor interface applications. Authorization Mode allows locking of critical configuration variables.
Measurement ranges in engineering units, adjustable alarm set-points, optional serial interfaces, and many other features offer flexibility to meet most demanding applications. Relay outputs allow control of beacons, horns and other alarm events. Three adjustable alarm levels are provided per channel. Two standard SPDT common alarm relays are for HORN, HIGH, WARN or FAULT alarm conditions.
The HA40 controller meets and exceed national, state and local safety regulations. Even the low-cost NEMA 4X model is CSA certified, CSA certified to C22.2 NO. 152 for combustible detection and Class I, Div. 2, Groups A,B,C,D CE mark NEMA 4X (Div. 2 certified). Explosion-Proof wall mount packaging options are also available.
||Wall mountable digital gas controller for industrial or commercial use|
||128 x 64 pixel graphic LCD with backlight displays, bar graphs, trends and engineering units|
|Common Alarm Relays (standard)
||Two, 5 amp 30VDC or 250VAC resistive Form C|
|Discrete Alarm Relays (OPTIONAL)
||Six 5 amp 30VDC or 250VAC resistive Form C|
|Analog Output (Optional)
||10 bit 4-20mA output. Max load 800 ohms with nominal 24VDC power supply.|
|Serial Port (Optional)
||Slave RS-485 port equipped with Tx / Rx LED’s|
Protocol = Modbus RTU
||100-240 VAC / 24 VDC are standard primary power supplies|
|Operating Temperature Range
||(-25 °C to +50 °C)|
||NEMA 4X / IP66 wall mount approved for Div 2|
NEMA 4X SS Enclosure wallmount approved for Div 2
||NEMA 4 = 5 pounds|
||2 Years Limited|
Each HA40 4 Channel Controllers come standard with- UL/CSA approved, Class I, Div 2 - NEMA 4X enclosure with magnetic input for non-intrusive control, 4 Channel 4-20 MA analog input, 2 - 5 Amp common relays, 6 - 5 Amp discrete relays, and internal 50W power supply.