MST RP010 10 CFM Respiratory Protector Carbon Monoxide Removal Systems
MST RP010AMST Only continuous use CO removal portable breathing air system on the market
Don't Just Filter...Purify with Modern Safety Technique's Low Temperature Catalyst to Remove CO
MST'S "RP" SERIES REMOVES "CO"............... DOES YOUR SYSTEM?
Rated Air Flow (Max) @ 100 psi 10 SCFM (4.7 L/s)
Operating Pressure 100 PSIG Dynamic (6.9 bar)
Inlet Pressure (Max) 150 PSIG Static (10.4 bar)
Outlet Pressure Range 0-125 PSIG (0-8.6 bar)
Operating Temp. Range 68-150oF (20-65oC)
Operating Relative Humidity 30-100% RH
(Inlet Air - Non Condensing)
Outside Dimensions 24"L x 18"W x 5.75"D
Weight (Including Monitor) 18 lbs
Replacement Filter Set RCRO010
Air from standard compressed air usually is contaminated with oil, water, dirt, rust, and often DEADLY CARBON MONOXIDE. The MST's RESPIRATORY PROTECTOR SERIES is a Four Stage Purification System that removes or reduces these contaminates and continually monitors the carbon monoxide level of the purified air.
5700 'CO' monitor is CSA Approved for Class1, Div. I, Groups A, B, C and D locations when utilizing 9 volt batteries.
There is nothing else like it!
MST's unique LT CAT low temperature catalyst offers significant benefits over all other CO removal systems. Because we use a precious metal catalyst, our Respiratory Protector Series Breathing Air Purification Systems convert carbon dioxide CO to carbon dioxide CO2 without the limitations you find with every other CO removal system on the market today:
No expensive desiccant dryers
With our LT CAT catalyst, you don't need dryers. Other systems require very dry air to function (4% relative humidity). To get air this dry costs a lot of money, primarily for desiccant drying towers. When you factor in the cost of buying, operating and maintaining a dryer, clean air for your workers can become very expensive.
Our Respiratory Protector Systems are designed to operate continuously. All other CO removal systems require drying time to remove moisture from saturated dryers. Continuous operation is possible with other companies' equipment, but they require twin towers, to alternate operation while moisture is purged...more equipment, more complexity, more cost!
Greater operator comfort
The ultra-dry air from all competitive systems is very uncomfortable for breathing! Respiratory Protector Systems provide comfortably humid air for operators, avoiding overly-dry nasal passages and discomfort.
At only 19 (RP010) the portable Respiratory Protector systems are easy to get to the jobsite.
Unique air distribution baffles
Maximize absorption and catalytic efficiency.
Total costs are much lower
By eliminating dryers, our unique design removes more than half of the cost for most systems compared to other CO removal equipment, making CO removal affordable for any operation.
Removes CO and other toxic gases including: ozone, nitric oxide, sulfur dioxide, nitrogen dioxide, hydrogen sulfide, ammonia, acetaldehyde, methyl chloride, methyl ethyl Lowest installed cost of any CO removal system (50%+ savings)
MST filters are recommended to changed periodically. Modern Safety Techniques replacement filters are available at a nominal cost.
Introduction to MST Repiratory Protector
MST Respiratory Protector - General Operation